Henny Penny Pressure Fryer Solenoid Valve Coil - 24V 60Hz (Part No. 29547)
Henny Penny Pressure Fryer Solenoid Valve Coil - 24V 60Hz (Part No. 29547)
⚠️ IMPORTANT – Please select the correct version for your country before purchasing.
This listing is for the 24V 60Hz coil (Part No. 29547) — suitable for Henny Penny fryers with a 24V low-voltage control circuit on a 60Hz supply (USA, Canada). If your fryer is in the UK or Europe (50Hz), you need Part No. 29575 instead.
About This Part
This is a replacement solenoid coil for Henny Penny commercial pressure fryers fitted with a 24-volt low-voltage control system. The coil is the electrical component inside the solenoid valve that generates the magnetic field to open and close the valve. If your solenoid valve coil has burned out or failed, fitting a new coil is a cost-effective alternative to replacing the entire valve assembly. This coil fits directly into the existing valve body — no need to replace the complete solenoid valve (Part No. 29515) unless the valve body itself is damaged.
How to Check if Your Coil Has Failed
Using a multimeter, measure resistance across the coil wires. A healthy 24V coil should read approximately 2.2 Ohms. A reading of zero (short circuit) or infinite (open circuit) indicates a failed coil that needs replacing.
🌍 Which Coil Do I Need?
| Country / Region | Control Voltage | Frequency | Correct Coil |
|---|---|---|---|
| 🇺🇸 USA / Canada | 24V | 60Hz | 29547 ✅ This listing |
| 🇬🇧 UK / 🇪🇺 Europe | 24V | 50Hz | 29575 — see separate listing |
| 🇺🇸 USA / Canada | 208–240V Mains | 60Hz | 18706 — different listing |
| 🇬🇧 UK / 🇪🇺 Europe | 208–240V Mains | 50Hz | 18726 — see separate listing |
Fits Models
Compatible with Henny Penny Pressure Fryer models using a 24V solenoid control circuit on 60Hz supply: PFE-500, PFE-500-CFA, PFE-561, PFE-591, PFE-600, CFA-500, CFA-600, Computron 7000, Computron 8000, MP-944, PFG-500, PFG-561, PFG-600, PFG-691, 500, 600.
This coil pairs with complete valve Part No. 29515 (24V 60Hz valve body).
Specifications
- Part Number: 29547
- Voltage: 24 VAC
- Frequency: 60 Hz
- Resistance: ~2.2 Ohms
- Dimensions: L 3.87" × W 2.0" × H 4.0"
- Weight: 0.65 lbs / 0.29 kg
- Compatible Valve Body: Part No. 29515
- Complete Valve Assembly: Part No. 29515 (sold separately)
Installation Notes
Always disconnect power before replacing. Remove the Tru-Arc retaining clip from the top of the coil housing, then remove the nameplate and cover. Disconnect the two coil wires at the wire nuts inside the coil housing. Remove the old coil and insert the new one. Coil wires can be reconnected in either order. Reassemble in reverse order.
This is an aftermarket replacement part designed for compatibility with the above Henny Penny pressure fryer models. Henny Penny® is a registered trademark of Henny Penny Corporation. This listing is not affiliated with or endorsed by Henny Penny Corporation.
No technical specifications available for this product.
