Henny Penny Pressure Fryer Solenoid Valve Coil - 120V 60Hz (Part No. 17106)
Henny Penny Pressure Fryer Solenoid Valve Coil - 120V 60Hz (Part No. 17106)
⚠️ IMPORTANT – Please confirm your fryer's coil voltage before purchasing.
This listing is for the 120V 60Hz coil (Part No. 17106) — suitable for Henny Penny fryers using a 120-volt solenoid coil, primarily found in USA and Canada models. This is a less common variant — most USA fryers use either the 208/240V or 24V coil. Check your existing coil or wiring diagram before ordering.
About This Part
This is a replacement solenoid coil for Henny Penny commercial pressure fryers fitted with a 120-volt solenoid circuit. The coil is the electrical component inside the solenoid valve that generates the magnetic field to open and close the valve. If your solenoid valve coil has burned out or failed, fitting a new coil is a cost-effective alternative to replacing the entire valve assembly.
How to Check if Your Coil Has Failed
Using a multimeter, measure resistance across the coil wires. A healthy 120V 60Hz coil should read approximately 50 Ohms. A reading of zero (short circuit) or infinite (open circuit) indicates a failed coil that needs replacing.
🌍 Coil Identification Guide
| Coil Voltage | Resistance | Frequency | Part Number |
|---|---|---|---|
| 120V | ~50 Ohms | 60Hz | 17106 ✅ This listing |
| 208–240V | ~150 Ohms | 60Hz | 18706 — different listing |
| 208–240V | ~245 Ohms | 50Hz | 18726 — see separate listing |
| 24V | ~2.2 Ohms | 60Hz | 29547 — see separate listing |
| 24V | ~2.2 Ohms | 50Hz | 29575 — see separate listing |
Tip: The resistance values above are the quickest way to identify exactly which coil is fitted to your machine — check with a multimeter before ordering.
Fits Models
Compatible with Henny Penny Pressure Fryer models using a 120V solenoid coil circuit: PFE-500, PFE-561, PFE-580, PFE-581, PFE-582, PFE-600, CFA-500, CFA-600.
Specifications
- Part Number: 17106
- Voltage: 120 VAC
- Frequency: 60 Hz
- Resistance: ~50 Ohms
- Dimensions: L 5.3" × W 3.75" × H 2.3"
- Weight: 0.53 lbs / 0.24 kg
Installation Notes
Always disconnect power before replacing. Remove the Tru-Arc retaining clip from the top of the coil housing, then remove the nameplate and cover. Disconnect the two coil wires at the wire nuts inside the coil housing. Remove the old coil and insert the new one. Coil wires can be reconnected in either order. Reassemble in reverse order.
This is an aftermarket replacement part designed for compatibility with the above Henny Penny pressure fryer models. Henny Penny® is a registered trademark of Henny Penny Corporation. This listing is not affiliated with or endorsed by Henny Penny Corporation.
No technical specifications available for this product.
