About This Kit

This is a complete solenoid valve repair kit for Henny Penny commercial pressure fryers. If your solenoid valve is leaking pressure or failing to hold pressure during the cook cycle, a worn or nicked Teflon seal is often the cause — and this kit allows you to restore the valve to full working order without replacing the entire valve assembly.

This is a universal kit — it is compatible with all Henny Penny solenoid valve variants: 18721, 18724, 29515 and 29698. No country or voltage selection required. One kit fits all.

What is Included in the Kit

The kit contains all internal seals and components required for a complete valve overhaul:

• Retainer clip (17101)
• Retainer spring (17109)
• Core spring (17110)
• Disc assembly core (17111)
• Bonnet gasket (17112)
• Seat, Teflon (17114)
• Disc spring guide (17115)
• Disc spring (17116)
• Retainer spring ring (17117)
• O-ring seal seat (17122)

Important: If any one seal is defective, all seals should be replaced. Do not replace individual seals only — always fit the complete kit.

When to Use This Kit

• Fryer is not building pressure during the cook cycle
• Pressure is dropping or leaking during cooking
• Solenoid valve is making hissing or leaking sounds
• Teflon seat is visibly nicked, worn or damaged
• Routine planned maintenance overhaul of the solenoid valve

Fits Models

Compatible with all Henny Penny Pressure Fryer models that use the standard solenoid valve assembly: PFE-500, PFE-561, PFE-580, PFE-581, PFE-582, PFE-591, PFE-600, PFE-680, PFE-682, CFA-500, CFA-600, Computron 7000, Computron 8000, PFG-500, PFG-561, PFG-600, PFG-691, MP-944, 500 series, 600 series.

Works with valve part numbers: 18721, 18724, 29515, 29698 — all variants, all voltages, all markets.

Specifications

• Part Number: 17120
• Kit Contents: 10 internal seal and spring components
• Valve Compatibility: 18721 / 18724 / 29515 / 29698
• Dimensions: L 5.25" x W 4.0" x H 2.0"
• Weight: 0.50 lbs / 0.23 kg

Installation Notes

The solenoid body must be removed from the fryer to replace the seals. Always disconnect power before starting. Remove the two adapter screws attaching the pipe adapter to the solenoid body, then remove the disc spring, guide and seat. Clean the valve body thoroughly. Wet the O-ring around the seal with water and insert the O-ring assembly flat side first through the IN side of the body. Use a pencil eraser to press the Teflon seal in until it snaps into place — do not nick or mark the seal as even the smallest nick will cause a pressure leak. Replace all O-ring seals and reassemble the valve.

This is an aftermarket replacement part designed for compatibility with the above Henny Penny pressure fryer models. Henny Penny® is a registered trademark of Henny Penny Corporation. This listing is not affiliated with or endorsed by Henny Penny Corporation.

No technical specifications available for this product.